Choose a downlight with the finder

The downlight finder checks your answers against every recessed downlight's own configurator, so a result is a build we actually make, not a guess. It takes about a minute.

The four questions

1. 1Where it goes: indoors and dry, damp, or wet. Damp needs IP44 or higher, wet needs IP65.
2. 2The ceiling: the ceiling material, and whether insulation will touch the housing. Insulation contact needs an IC rated housing.
3. 3The look: trimless, thin flange or no preference, and round, square or either.
4. 4The light: one warm white, dim to warm, tunable white or not sure, and how it is dimmed.

Click Show the downlights after the last step.

Reading the results

• Each downlight that fits shows the options the finder chose for you. Click Open it set up this way to land on its configurator with those choices made.
• If nothing fits every answer, the finder shows the closest downlights and names the one point each one misses.
• Your answers sit above the results. Click any of them to change it, or Start over.
• Downlights run on a remote driver. Find its driver on a result carries the build straight to the driver finder. See find the driver for your fixtures.

Common questions